928 Tint Blog · October 19, 2026 · 5 min read
Paint Protection Film on a 2026 Ram 1500 RHO
A brand new 2026 Ram 1500 RHO came into the shop in Prescott Valley with an owner who did not want the first gravel road to leave its mark. The ask was paint protection film on the spots that take the abuse. Here is what we put on it, why we chose those spots, and how the job goes.
What stage 2 covers
We sell paint protection film in stages so you only pay for the panels that actually get hit. Stage 2 on this truck was:
- The front quarter of the hood, including the leading edge
- The front quarter of both fenders
- The rocker panels, front wheel to rear wheel, on both sides
That is the hood and fenders where highway rocks land, plus the rockers that catch everything the front tires throw back. On a stock truck the rockers are a nice-to-have. On an RHO they are the first thing to protect.
Why the RHO needs it more than most
The RHO is the off-road Ram 1500. It sits on 35-inch tires with wide fender flares, and the hood is tall with a big scoop in it. Three things follow from that:
- The tires throw more. Big, open-tread tires pick up gravel and fling it straight into the rockers and the back of the front fenders. That is why stage 2 runs the rockers front to rear instead of stopping at the door.
- The hood is a wall. A tall, flat hood face takes highway hits head-on. The first quarter of the hood sees most of them.
- It will see dirt. Nobody buys an RHO to keep it on pavement. Trail brush drags along the rockers and the lower fenders, and film takes that scuffing instead of the clear coat.
Around here that means Highway 69 and 89A on the way to the trail, then forest roads on the far side. The film is for both.
How the install goes
Paint protection film is thicker than window film, and it goes on the outside of the truck, so prep matters more than anything else.
- Wash and decontaminate. Even a new truck has rail dust and road grime on it. Anything left on the paint ends up under the film for good.
- Open everything up. The hood comes up so the film can wrap the leading edge instead of stopping short of it. Wheel liners and trim get masked where the rocker film tucks behind them.
- Lay it wet. The film goes down on slip solution so it can be floated into place, then it is squeegeed from the center out to push the water to the edges.
- Set the edges. Edges are tucked or wrapped where the panel allows, then warmed so the adhesive bites. This is the step that decides whether a job lifts in a year or never.
- Let it cure. The truck sits for a bit before it leaves, and the owner gives it a few days before the first wash.
What it costs
Price depends on the truck and the coverage. Stage 1 is the least, stage 2 is the middle, and a full front is the most, mostly because the bumper and mirrors are the slowest panels to film. Send us the year and model through the quote form or text (928) 447-8698 and we will give you a straight number for your truck. If you are also tinting the front doors to match the rear glass, we do both in the same visit.
Film and tint in one stop
Most trucks that come in for film also need the front doors tinted to match the factory privacy glass, and a lot of them leave with a windshield protection film too. Bring it by the shop at 8733 E Laredo Dr in Prescott Valley, or ask about pickup if you cannot get it here.
928 Tint is a window tinting shop in Prescott Valley serving Prescott and the rest of Yavapai County, with pickup or mobile service if you cannot get to the shop. Send a quote request or call (928) 447-8698.